 |
Termination
Stud
System
|
 |
|
Attachment: Our Termination Stud System is very simple to setup and install.
Simply drill holes in your verticals for the cable to pass through. The termination cap pulls against the last vertical to tension.
Examples of Applications: This system is very good for retrofitting existing rails to meet current codes.
Termination Studs are a very cost effective and clean method of installing and tensioning cable assemblies because they can be used with any type
or style of post. The termination shaft on the turnbuckle is available in different lengths to pass through various post sizes.
Other Information: Our standard termination stud turnbuckle can be used for up to a 2" OD
post on a level or angle run. Rods are also available for
6", and 12" posts.(316 grade stainless steel).
|
|
Countersunk
Termination Stud System
For a flush fit. More information.
|
 |
| adjust-a-balls are used for
stair angle compensation. These half round balls allow for the
cable to swivel to the proper stair angle automatically. Simply
drill the proper hole and the ball will adjust to the proper
position as the cable is tensioned. |
|
ball size (s)
|
hole size(t)
|
catalog #
|
|
3/4"
|
25/64"
|
AJB
|
Adjust-a-balls will fit up to 1/4" cable.
Holes in end posts must be drilled to 11/16"
|
 |
more
downloads 
