WireTeknik
Swaging Instructions
|
Hayn Enterprises, LLC |
 |
1. Choose the roller pair of dies that corresponds to the
cable diameter and slip them into the cogwheel synchronising pins. The
arrows on the dies should always be in swaging direction |
 |
2. Attach the terminal to the attachment fixture on the drawing
arm and adjust the length of the drawing arm so the roller dies meet on
the terminal shank at the desired position. |
 |
3. Apply just enough hydraulic pressure so the roller hold
the terminal firmly. Then mark and insert the cable to the bottom of the
terminal throat. |
 |
4. Move in to position the transparent face protector. Apply
hydraulic pressure to draw the terminals between the roller dies. |
 |
5. When they rotates, they will press the terminal shank
onto the wire rope. |
 |
6. Measure the diameter of the terminal shank after swaging. |
Important Notes.
This swager is designed to reduce the terminal shank to the required
diameter in one pass. However variations in the dimensions of the terminal
or cable or material hardness may make two passes necessary.
When swaging solid rod, that a special swaging compound must be used.
After swaging, wipe off the roller dies and spray the dies and the swager
with a corrosive preventative.
|
www.haynmarine.com
800.346.4296
courtesy
of
wireteknik.se
|